Kenwood B60-5632-00 Manuel d'utilisateur télécharger pdf (Page 15)

GND

ANTENNA

Setting up the system

Connecting the antennas

The broadcast reception cannot be made unless the antennas are

connected. Connect the antennas correctly as instructed below.

AM loop antenna

Place the supplied loop antenna as far as possible from the receiver, TV

set, speaker cords and power cord, and adjust the direction for best

reception.

FM indoor antenna

The supplied indoor antenna is for temporary use only. For stable signal

reception we recommend using an outdoor antenna. Disconnect the

indoor antenna when you connect one outdoors.

FM outdoor antenna

Lead the 75Ω coaxial cable connected to the FM outdoor antenna into the

room and connect it to the FM 75Ω terminal.

AM antenna terminal connections

1 Push lever. 2 Insert cord. 3 Release lever.

FM antenna terminal connections

Insert cord.

Use an antenna

adapter

(Commercially

available)

Attach to the

stand

AM loop antenna

FM indoor antenna

FM outdoor antenna

1 Strip coating.

2 Push the lever.

3 Insert the cord. 4 Return the lever.

Connecting the terminals

Speaker impedance

After confirming the speaker impedance indications printed on the

rear panel of this model, connect speakers with matching impedance

ratings. Using speakers with a rated impedance other than that

indicated on the rear panel of this model could result in malfunctions

or damage to the speakers or this model.

• Never short circuit the + and – speaker cords.

• If the left and right speakers are connected inversely or the speaker

cords are connected with reversed polarity, the sound will be unnatural

with ambiguous acoustic imaging. Be sure to connect the speakers

correctly.

Speaker placement

*For Surround Back speaker, you may place either two Surround

Back speakers (Surround Back Left speaker and Surround Back

Right speaker) for 7.1 channel surround sound system or one

Surround Back speaker for 6.1 channel surround sound system.

Front speakers: Place the left and right speakers at each side of your

TV. Angle the speakers towards the listening area to enhance the

stereo effect.

Center speaker: Place the center speaker on the center between the

front left and right speakers. Tilt the speaker upward or down-ward

so that it is directly facing the listening area.

Surround speakers: Place the surround speakers as high as possible,

either directly to the sides of the listening area or else slightly behind

the listening area. Adjust the angles so that these speakers are facing

directly towards the listeners.

Subwoofer: Usually, place the subwoofer in the front center position

in the listening room, near one of the front speakers. (Since the

subwoofer has less directivity than other speakers, it can be placed

almost in any position that can offer the best low frequency

reproduction according to the room layout.)

Surround Back speaker/s: Place the surround back speaker behind

the listening position, at the same height as the left and right surround

speakers.

• Although the ideal surround system consists of all the speakers

listed above, if you don’t have a center speaker or a subwoofer, you

can divide those signals between the available speakers in the

speaker settings steps to obtain the best possible surround

reproduction from the speakers you have available. ^

Front

speaker

Subwoofer

Surround

speaker

Center speaker

Listening

position

*Surround

Back speaker

* Surround

Back Right

speaker

* Surround

Back Left

speaker

5632_08_15_EN 06.4.20, 2:00 PM15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Kenwood B60-5632-00 Manuel d'utilisateur Page 15

Commentaires sur ces manuels