Kenwood TM-441A Manuel d'utilisateur télécharger pdf (Page 39)

4. Set the second digit with the tuning control, then

press the MHz/LOCK key.

The third digit will flash.

5. Set the third and fourth digits. When the fourth digit

has been set, the DRS setting mode will be

automatically reentered.

OThe digits can be set with the MC-44DM (option).

Perform steps 1 and 2, and key in the number with

the numeric keys.

Each time a key is pressed, a digit is set. When all the

digits have been set, the frequency will be displayed

again.

5-9-9 Setting the DTMF Control Mode

1. Select the receive frequency.

2. Enter the DRS setting mode, and specify the number

of phrases, sound level, and ID number. (See Sections

5-9-1/2, 5-9-5, and 5-9-8.)

3. While in this state, press the F key for longer than 1

second, then press the DR/DT key while the F indica

tor is flashing. The frequency will be displayed again

and the DRS indicator will flash.

4. Press the F key. The DRS indicator will stop flashing

and stay on. The transceiver will be ready to be con

trolled remotely.

The automatic recording mode will be ignored, as will

the DTSS and paging modes.

5-9-10 External Control Method

For external control, recognition code # or ♦ will

transmit a four-digit ID number and three-digit

command code.

# 1 2 3 4 * 0 1

Leading zeroes in the ID number can be omitted.

•List of DTMF commands

See next page

Note;

To transmit a DTMF signal, press a key within five

seconds of pressing the preceding key. If there is a

time delay of longer than five seconds, the DTMF

signals that have been transmitted will be cleared.

1 second.

3 9

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 58 59

Pas de commentaire

Kenwood TM-441A Manuel d'utilisateur Page 39