Kenwood DDX5026 Manuel d'utilisateur télécharger pdf (Page 10)

DNX SERIES/ DDX SERIES

Removing Monitor/Player Unit

Removing the Hard Rubber Frame

(escutcheon)

1. Engage the catch pins on the removal tool 6 and

remove the two locks on the lower level.

Lower the frame and pull it forward as shown in

the figure.

Accessory 6

Lock

Catch

⁄

• The frame can be removed from the top side in the same

manner.

2. When the lower level is removed, remove the

upper two locations.

Removing the Unit

1. Remove the hard rubber frame by referring to the

removal procedure in the section <Removing the

Hard Rubber Frame>.

2. Insert the two removal tools 6 deeply into the

slots on each side, as shown.

Accessory 6

3. Lower the removal tool toward the bottom, and

pull out the unit halfway while pressing towards

the inside.

⁄

• Be careful to avoid injury from the catch pins on the

removal tool.

4. Pull the unit all the way out with your hands, being

careful not to drop it.

B54-4763-00_00_DNX5_E_En_r1.indd 10B54-4763-00_00_DNX5_E_En_r1.indd 10 09.11.11 5:36:35 PM09.11.11 5:36:35 PM

1 2 ... 5 6 7 8 9 10 11 12

Pas de commentaire

Kenwood DDX5026 Manuel d'utilisateur Page 10