Kenwood CX-SR10 Manuel d'utilisateur

CX-SR10Sirius®Satellite AntennaInstallation Manual©2002 Kenwood USA Corporation. All Rights Reserved.

Installing on ConvertiblesOn convertibles the antenna module should be located on the centerline of thetrunk approximately 6 inches from the rear wind

3. Drill a small hole or cut a gap into the rubber sleeve and lead the cable throughthe interior trim to the receiver.Figure 21: Entering the interior

Installing on SUVs, Minivans and 5-Door VehiclesThe antenna module should be located on the centerline of the roof, not less than 4inches from the gap

2. Route the cable between the roof and the tailgate to the inside. Take advantageof any existing cable channel or wiring conduit.3. There are two alt

Mounting on Pickup TrucksThe antenna module should be mounted on the centerline of the roof approximately4 inches from the rear of the cab. The cables

15

Internetwww.kenwoodusa.comE-mmailinquiry@kenwoodusa.comTelephone1-8800-KKENWOODMain OOfficeP.O. BBox 222745Long BBeach, CCA 990801-55745®2002 Kenwood

2

Introduction Your Sirius satellite antenna, approved by Sirius Satellite Radio, Inc., has been spe-cially designed to receive signals from Sirius&apos

Mechanical data:Electrical data:General Instructions Satellite antennas are extremely sensitive and finely specified to facilitate receptionof satelli

Shortening the antenna "tail"The antenna module is supplied with a 6 inch tail. For vehicles with flat roofs (SUVs,Mini-vans) and for conver

Installing on SedansThe antenna module should be located along the centerline of the roof, at least 4inches from the rear window.Figure 7: Installed a

Figure 9: Cables routed separatelyTwo types of window moldings (Outside and Encapsulated) are used on most vehi-cles. Both are suitable for concealing

Figure 12: Cables routed in standard molding6. Route the cable from the lowest point of the rear window into the trunk area.Take advantage of any exis

7. If there is no suitable cable channel, the cable may be routed directly from thewindow molding to the right or left corner of the trunk.Figure 15: