Kenwood TK-5210 Manuel d'utilisateur

© B62-1796-10 (K)09 08 07 06 05 04 03 02 01INSTRUCTION MANUALMANUAL DE INSTRUCCIONESVHF APCO P25 TRANSCEIVERTRANSCEPTOR APCO P25 VHFTK-5210

PREPARATION INSTALLING/ REMOVING THE (OPTIONAL) BATTERY PACK CAUTION: -DO NOT RECHARGE HE BATTERY PACK IF IT IS ALREADY FULLY CHARGED. DOING SO MA

THE ANTENNA INSTALLING Screw the antenna into the connector on the top of the transceiver by holding theantenna at its base and turning it clockw

INSTALLING THE COVER OVER THE UNIVERSAL CONNECTOR If you are not using the optional KMC-** speaker/ microphone, install the cover over the universal

RADIO FREQUENCY ENERGY SAFETY INFORMATION _____This KENWOOD transceiver has been tested and compli

iWARNING:EXPLOSIVE ATMOSPHERES (GASES, DUST, FUMES, etc.)Turn off your transceiver while taking on fuel, or while parked ingasoline service stations.◆

iiOne or more of the following statements may beapplicable:ATTENTION (U.S.A. Only):The RBRC Recycle seal found on KENWOODnickel-cadmium (Ni-Cd) batter

UNPACKING AND CHECKING EQUIPMENT Note: The following unpacking instructions are for use by your KENWOOD dealer, an authorized KENWOOD service facili

Front No. Name Correspondence Note 1 PF A key Type 2/3 2 PF B key Type 2/3 3 PF C key Type 2/3 4 PF D k

Side No. Name Correspondence Note 1 Side1 key Type 1/2/3 2 PTT Type 1/2/3 3 Side2 key Type 1/2/3 4 Side3 key

Key Type1 Type2 Type3 (Power SW/Volume) Power Switch/Volume Power Switch/Volume Power Switch/ Volume (Selector) 16 Position Rotaly SW 16 P

1.1 LCD(Type2,Type3) Standard Display (2Line) Message Display (3Line) Conventional Trunking