Kenwood KRF-X9060D Manuel d'utilisateur télécharger pdf (Page 26)

Listening to a source component

VOLUME CONTROL

VOLUME /

INPUT SELECTOR

Input Selector AV AUX

Use the Input Selector and AV AUX keys to select the

source you want to listen to.

Selecting a source using each key.

1 “DVD/6CH”

2 “CD/DVD”

3 “PHONO”

4 “TUNER”

5 “VIDEO 1”

6 “VIDEO 2”

7 “VIDEO 3”

8 “MD/TAPE”

9 “AV AUX”

Start playback from the selected source.

Use the VOLUME CONTROL knob or VOLUME +/

keys to

adjust the volume.

Preparing for playback

Some preparatory steps are needed before starting playback.

INPUT MODE

MD/TAPE

POWER ON/OFF

(KRF-X9060D)

POWER

ON/STANDBY

(VR-6070)

ON/STANDBY

(KRF-X9060D)

A SPEAKERS B

Turning on the receiver

1 Turn on the power to the related components.

2 Turn on the power to this receiver by pressing the POWER ON/

STANDBY

(for VR-6070) or POWER ON/OFF and ON/STANDBY

(for KRF-X9060D) key.

Selecting the input mode

If you have selected a component connected to the CD/DVD, VIDEO 2,

VIDEO 3 or DVD/6CH jacks, make sure that the input mode setting is

correct for the type of audio signal to be used. 9

Selecting MD/TAPE

Select the source name corresponding to the component connected to

the MD/TAPE jacks. The initial factory setting is “TAPE”. To change the

source to “MD”, follow the steps below:

Hold down the MD/TAPE key for more than 2 seconds.

• The source indication changes to “MD”.

• To return to the original indication, repeat the above procedure.

Selecting the speaker system

Press the A SPEAKERS B key to select the speaker system to be

used.

A ON :

Sound from the speakers connected to the SPEAKERS A

terminals on the rear panel.

B ON : Sound from the speakers connected to the SPEAKERS B

terminals on the rear panel. No sound will be heard from the

subwoofer.

A+B ON : Sound from both the speakers connected to the SPEAKERS

A and B terminals on the rear panel.

A+B OFF : No sound from the speakers. Use this setting when listening

with headphones for stereo sound in all playback modes.

The display segments are different depending on the type of

input signal.

The indicator for the speakers

you want to use should be lit.

SL S SB SR

C R

SP MUTE

OPTICAL 6CH INPUT

COAXIAL ANALOG 96kHzfs

CINE

ACTI

DSP

A B CLIP

AUTO DETECT

LFE

• Selecting “6CH INPUT” by pressing the INPUT MODE key, whereby

“DVD/6CH” is the input source will cause SPEAKERS A to be selected

automatically.

Normal playback

•VR6070/23-32/EN 3/26/02, 2:33 PM26

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

Kenwood KRF-X9060D Manuel d'utilisateur Page 26

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteurs et amplificateurs Kenwood KRF-X9060D