Kenwood CMOS-300 Manuel d'utilisateur télécharger pdf (Page 3)

100

English

• Insulate unconnected wires with vinyl tape or other similar

material. To prevent a short circuit, do not remove the caps

on the ends of the unconnected wires or the terminals.

• After the unit is installed, check whether the brake lamps,

blinkers, wipers, etc. on the car are working properly.

• Install so that it does not obstruct the rear ﬁ eld of view.

• Install so that it does not protrude from the side of the car.

• Do not perform installation in rain or fog.

• When humidity is high, dry the surface to which the unit is to

be attached before installing.

• Moisture on the attachment surface reduces adhesive

strength, which may lead to the unit coming oﬀ .

• Do not attach the camera bracket to areas on the car body

treated with ﬂ uorocarbon resin, or glass.

• May result in the rear view camera falling oﬀ .

- Do not apply water to the unit.

- Do not expose the unit to rain.

- Do not subject the camera to unnecessary force.

- Thoroughly clean where tape is used for sticking on the

unit.

• Refer to the Instruction’s manual for details on connecting

the other units, then make connections correctly.

• Secure the wiring with cable clamps or adhesive tape. To

protect the wiring, wrap adhesive tape around them where

they lie against metal parts.

• Route and secure all wiring so it cannot touch any moving

parts, such as the gear shift, handbrake and seat rails.

• Do not route wiring in places that get hot, such as near the

heater outlet. If the insulation of the wiring melts or gets torn,

there is a danger of the wiring short-circuiting to the vehicle

body.

• When replacing the fuse, be sure to use only fuse of the

rating prescribed on the fuse holder.

• To minimize noise locate the TV antenna cable, radio antenna

cable and RCA cable as far away from each other as possible.

• Do not install the power supply box unit in places where it

may become subject to high temperatures or humidity, such

as:

- Places close to a heater, vent or air conditioner.

- Places exposed to direct sunlight, such as on top of the

dashboard or the rear shelf.

- Places that may be splashed by rain, for example close to

the door.

• Lay the cords by avoiding high-temperature areas. Use

corrugated tubes for wiring inside the engine room. If a cord

contacts a high-temperature area of the vehicle, the coating

may melt and cause short-circuiting, which may lead to a ﬁ re

or electric shock hazard.

Accessories

Camera (with camera bracket) ..........1

Camera connection cord ..........1

Power supply box..........1

Double-side adhesive tape (Large)..........1

Power cord ..........1

Switch unit..........1

Double-side adhesive tape (Small) ..........1

CMOS-300 only

The head unit connection cord is used for connection to

a Kenwood car navigation system equipped etc. with the

camera control function.

Waterproof packing ..........1

Camera bracket clamping screw..........1

Head unit connection cord ..........1

1 2 3 4 5 6 7 8 ... 99 100

Commentaires sur ces manuels

Pas de commentaire

Kenwood CMOS-300 Manuel d'utilisateur Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Non Kenwood CMOS-300