Kenwood HM-233 Manuel d'utilisateur télécharger pdf (Page 20)

Radio

- Listening to the Radio -

Listening to the Radio

To receive an FM stereo transmission:

Press the FUNCTION (BAND) button to display the "ST" indicator.

l " " will appear when an FM broadcast is in stereo.

l If the FM reception is weak, press the FUNCTION (BAND) button to extinguish the

"ST" indicator. The reception changes to monaural, and the sound becomes

clearer.

After use:

Press the ON/STANDBY button to enter the power stand-by mode.

1 Press the ON/STANDBY button to turn the power on.

2 Press the FUNCTION button until "FM" or "AM" appears on the dis-

play.

When operating with the remote control, press the TUNER button, and then the

BAND button to select "FM" or "AM".

3 Press the TUNING ( or ) button to tune in to the desired station.

Manual tuning:

Press the TUNING button as many times as required to tune in to the desired

station.

Auto tuning:

When the TUNING button is pressed for more than 0.5 seconds, scanning will

start automatically and the tuner will stop at the first receivable broadcast station.

Notes:

l This can be operated by pressing the TUNE ( or ) button on the remote

control.

l When radio interference occurs, auto scan tuning may stop automatically at

that point.

l Auto scan tuning will skip weak signal stations.

l To stop the auto tuning, press the TUNING button again.

FM stereo mode indicator

FM stereo receiving indicator

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Kenwood HM-233 Manuel d'utilisateur Page 20