Kenwood DNX7210BT Manuel d'utilisateur télécharger pdf (Page 8)

1414 15

Return to the Top page

Basic Operations

Return to the Top page

Basic Operations

SD card

DNX7210BT: Press the <0>

button for 1 second to open the

front panel.

The panel fully opens.

DNX5210BT/ DNX5510BT:

Detach the front panel.

NOTE

• Forhowtodetachthepanel,seeDetaching The

Front Panel (P.15).

Hold the SD card as the diagram

below and insert it into the slot

until it clicks.

Notchedsection

Labeledside

The unit loads the card and playback

starts.

● To remove:

Push the SD card until it clicks and then

remove your finger from the card. The

card pops up so that you can pull it out

with your fingers.

External device

Insert the plug into the AV-IN jack.

Detaching The Front

Panel

Youcandetachthefrontpaneltoprevent

theft.

Press the <0> button for

1 second to open the front panel.

NOTE

• Youcansetthefrontpaneltoopenautomatically

whentheignitionisturnedoff.SeeMonitor

angle control (P.74).

Detach the panel as the diagrams

below.

NOTE

• Theattachingplateclosesautomaticallyinabout

10secondsafterthefrontpanelisreleased.

Removethepanelbeforethishappens.

Detach the panel as the diagrams

below.

● After detaching:

Putthepanelintheprotectivebag

suppliedwiththeunit.

NOTE

• Topreventdeterioration,donottouchthe

terminalsoftheunitandfaceplatewithyour

fingers.

• Iftheterminalsontheunitorfaceplategetdirty,

wipethemwithacleansoftdrycloth.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 57 58

Commentaires sur ces manuels

Pas de commentaire

Kenwood DNX7210BT Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteur GPS Kenwood DNX7210BT