Kenwood th-k20a Manuel d'utilisateur télécharger pdf (Page 46)

USING DCS

1 Press [TONE] 3 times to activate the DCS function.

• Each time you press [TONE], the selection changes as follows:

Tone (

) ➡ CTCSS ( ) ➡ DCS ( ) ➡ Cross Tone ( ) ➡ Off (no display).

• The “

” icon appears when the DCS function is ON.

2 Press [T.SEL].

• The current DCS code appears on the display and blinks.

3 Rotate the ENC control to select your desired code.

• To exit the DCS code selection, press [PTT].

4 Press any key other than [MONI], [LAMP], or [PTT] to set the selected

frequency.

5 When you are called: The transceiver squelch opens only when the selected

DCS code is received.

When you make a call: Press and hold [PTT], then speak into the

microphone.

DCS CODE SCAN

This function scans through all DCS codes to identify the incoming DCS code on

a received signal. You may find it useful when you cannot recall the DCS code

that the other persons in your group are using.

1 Press [TONE] 3 times to activate the DCS function.

• Each time you press [TONE], the selection changes as follows:

Tone (

) ➡ CTCSS ( ) ➡ DCS ( ) ➡ Cross Tone ( ) ➡ Off (no display).

• The “

” icon appears when the DCS function is ON.

2 Press [T.SEL] (1s) to run the DCS Code scan.

• Scan starts and “DCS.SCN” appears on the display.

• When a DCS code is identified, the identified code appears on the display and

blinks.

3 Press [T.SEL] to program the identified code in place of the currently set DCS

code.

• If you do not want to program the identified code, press any key other than [MONI],

[LAMP], or [T.SEL].

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 67 68

Pas de commentaire

Kenwood th-k20a Manuel d'utilisateur Page 46