Kenwood TK-2202L Manuel d'utilisateur télécharger pdf (Page 24)

SCAN

Scan is useful for monitoring signals on the transceiver

channels. When scanning, the transceiver checks for a signal

on each channel and only stops if a signal is present.

The transceiver will remain on a busy channel until the signal

is no longer present. Your dealer programs the delay time

between signal drop-out and Scan resumption. If a signal is

received during the delay time, the transceiver will remain on

the same channel.

Note: You can only use Scan if your dealer has programmed at least

2 channels and they are not locked out of Scan.

To start scanning, momentarily press the key programmed as

either Scan or Scan + Temporary Delete.

• Scanning starts from the current channel and ascends

through the channel numbers.

• The LED indicator flashes green.

• When a signal is received on a channel and signalling

matches, the LED indicator lights green.

To end Scan, press the Scan or Scan + Temporary Delete

key again.

■ Priority Scan

If enabled, a priority channel is set up one of two ways:

•Your dealer may set up a fixed priority channel on your

transceiver.

•You can select your own priority channel, prior to

scanning, using the Channel selector.

During Scan, if a priority channel has been set up on your

transceiver, the transceiver will automatically change to

the priority channel when a call is received on it, even if a

call is being received on a regular channel.

The transceiver will remain on the Priority channel until the

signal drops out. Your dealer programs the delay time

between signal drop-out and scan resumption.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Pas de commentaire

Kenwood TK-2202L Manuel d'utilisateur Page 24