Kenwood AUDIO PROCESSOR Manuel d'utilisateur

OPERATING MANUALEQplusAUDIOPROCESSOR

REAR PANEL CONTROLS191822202324212225(18) MIC SELECT This three position switch selects the YAESU, KENWOOD or ICOM mi

REAR PANEL CONTROLS-11-(20) MIC INPUT This RCA female connector is used as a microphone input. This connector works

-15-REAR PANEL CONTROLS(23) AUDIO OUTPUTS 1,2 and 3 The audio output and PTT outputs of the EQplus uses these 5 pin DIN’s. When t

-16-GETTING STARTED TUTORIALBefore plugging the power transformer into the wall, preset theEQplus controls as indicated: Power , Equalizer,

GETTING STARTED TUTORIAL-17-Audio Input Gain (5) so that 2 or 3 Green Bar Graph LED’s light up. This may require adjusting both the Mic Gain cont

-18-GETTING STARTED TUTORIAL - Turn the Compressor control (11) fully counter clockwise. This setting passes uncompressed audio thru the comp

The Level control (15) sets the amplitude that the audio delayedby the Effects Processor combines with the non delayed audio.Through experimentation

MIC INPIN 1PIN 7INTERNAL WIRING-20-

-21- AUDIO OUT 1/2/35 Pin Male DIN Din connectors shown on side to be solderedGndPTT- Audio+ AudioBalanced OutputHi-Z OutputLow Impedance Balanced O

AUDIO OUT CABLE WIRING-22-Alinco DX77Kenwood TS130/140 TS430/440 TS850/TS870 TS930/940/950SG2020K2 Japan Radio JST-135 JST-245Yaesu FT99

September 2004Julius D. Jones19 Vanessa LaneStaatsburg, N.Y. (12580)(845) 889-4253E-mail: [email protected] Page: http:// www.w2ihy.com c 2004

AUDIO OUT & POWER CABLE WIRINGDRAKE TR7DRAKE T4XB COLLINS 32S 1, 32S3COLLINS KWM2ACOLLINS 32V2, 32V3HallicraftersE.F. JohnsonHI-ZHI-ZYaesuFT101EF

AUDIO OUT CABLE WIRINGDIN connectors shown on the side to be soldered DO NOT SOLDER TO SHIELD OF DINHI-ZLOW Z TRS BALANCED OUTPUT LOW Z UN

TABLE OF CONTENTSIntroduction ... 4Front Panel Controls ... 5 - 9 Rear Panel Controls ...10 - 11Schematic (Fr

-4-The EQplus is the next generation of audio processing equipment from W2IHY Technologies. The EQplus was designed to be directly attached to the wor

-5-FRONT PANEL CONTROLS126This section describes each of the controls on the front panel. You should read through this section now. Some of the descr

FRONT PANEL CONTROLS-6-(4) Audio Input Impedance Switch (S5) This 3 position toggle switch is used to change the input impedance of the Mic

FRONT PANEL CONTROLS(7) Equalizer On/Off Switch (S3) This switch turns the Equalizer on and off. When the equalizer is off, adjusting the

FRONT PANEL CONTROLS Incoming signals will have up to 20dB of compression introduced. The EQplus compressor circuitry contains a limiter

FRONT PANEL CONTROLS(14) EFFECTS PROCESSOR DELAY Potentiometer (R42) This potentiometer works only if the Effects Processor 3 position