Kenwood AUDIO PROCESSOR Manuel d'utilisateur télécharger pdf (Page 11)

REAR PANEL CONTROLS

-11-

(20) MIC INPUT

This RCA female connector is used as a microphone

input. This connector works independent of the Mic Select

switch (18) and may be used for another audio input

source such as a microphone. The impedance of this

input is set by the Audio Input 3 position toggle switch (4).

(21) AUX INPUT

This 5 Pin Din connector allows audio to be brought into

the EQplus from an external device..This connector

works independent of the Mic Select switch (18) and may

be used for another audio input source such as a

W2IHY 8 Band EQ. The impedance of this input is set by

the Audio Input 3 position toggle switch (4).

(22) PTT INPUT

This female RCA connector is for push to talk control. A foot

switch or other device may be connected. Grounding the

center of the connector grounds the push to talk line on the

selected Audio Output.

(22) OUTPUT SELECT

This three position rotary switch directs audio to one of 3

5 Pin DIN connectors (Output1, Output 2 or Output 3.)

Gnd

PTT

- AUDIO IN

+ Audio IN

AUX INPUT

5 Pin Male DIN

Din connectors shown

on side to be soldered

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 20 21

Pas de commentaire

Kenwood AUDIO PROCESSOR Manuel d'utilisateur Page 11