Kenwood TM-V71E Manuel d'utilisateur télécharger pdf (Page 101)

INSTALLING THE VGS-1 UNIT

Follow the instructions below to install the VGS-1 unit.

cushion

connector

1 Remove the 8 screws from the cover of

the base unit, then remove the cover itself

from the unit.

2 From the 5 black cushions supplied with

the VGS-1, select the thickest rectangular

cushion (20 x 30 x 12 mm) and attach it to

the top surface of the VGS-1 unit.

• To prevent interferece to the terminal of the

VGS-1, ensure that you attach the thick

square cushion to the baseplate surface.

3 From the remaining cushions, select the

thickest square cushion (21 x 21 x 2.5

mm) and attach it to the printed circuit

board.

• The remaining cushions are not used

with this transceiver.

• Ensure that the cushion is placed within the

guidelines on the PCB.

4 Insert the VGS-1 unit into the connector

on the transceiver.

• Press down on the top of the VGS-1 unit

to ensure that it is securely attached to the

connector.

5 Replace the cover on the base unit and

secure it using the 8 screws.

VGS-1

cushion

guidelines

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 107

Pas de commentaire

Kenwood TM-V71E Manuel d'utilisateur Page 101