Kenwood TM-V71E Manuel d'utilisateur télécharger pdf (Page 52)

MEMORY SCAN

Use Memory Scan to monitor all Memory channels programmed with frequency

data.

1 Select your desired band.

2 Press [MR] (1s).

• Scan starts at the current frequency.

• The 1 MHz decimal blinks while scanning is in progress.

• To reverse the scan direction, turn the

Tuning control clockwise (upward scan) or

counterclockwise (downward scan). You can also press microphone [UP]/ [DWN].

3 To quit Memory Scan, press [MR] again.

Note:

u At least 2 Memory channels must contain data and must not be locked out of scan.

u The L0/U0 to L9/U9 Memory channels will not be scanned.

u You can also start Memory Scan when in Channel Display mode. While Scan is paused on a

channel, the channel number blinks.

n Locking Out a Memory Channel

You can select Memory channels that you prefer not to monitor while scanning.

1 Press [MR], then rotate the Tuning control to select your desired channel.

2 Enter Menu mode and access Menu 202 (L.OUT) {page 20}.

3 Set the lockout to ON to lock the channel out of the scanning sequence.

• To cancel lockout, set the lockout to OFF.

• The icon appears on the display for a channel that has been locked

out.

Note: The L0/U0 to L9/U9 Memory channels cannot be locked out.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 106 107

Pas de commentaire

Kenwood TM-V71E Manuel d'utilisateur Page 52