Kenwood TK-3202 Manuel d'utilisateur télécharger pdf (Page 20)

■ Temporary Delete

If a key is programmed with the Temporary Delete or

Scan + Temporary Delete function, you can temporarily

remove specific channels from the scanning sequence

during Scan. When Scan stops at a channel, you can

remove that channel from the scanning sequence by

pressing and holding the key programmed as Temporary

Delete or Scan + Temporary Delete for 1 second.

•You cannot delete the Priority channel, if one has been

set up.

•You cannot delete a channel if there will be less than

2 channels available for scanning remaining.

•To add the channel back into the Scan list, simply exit

Scan mode or switch the transceiver OFF and then ON

again.

■ Revert Channel

During Scan, pressing the PTT switch to transmit will

cause the transceiver to select the revert channel. Your

dealer can program the revert channel using one of the

following methods:

• Selected: The last channel selected is assigned as

the new revert channel.

• Selected + Talkback: If the channel has been

changed during Scan, the newly selected channel is

assigned as the new revert channel. However, the

transceiver also transmits on the channel where Scan

is currently paused.

• Priority: If your dealer has programmed a Priority

channel, it is the revert channel.

• Priority + Talkback: If your dealer has programmed a

Priority channel, it is the revert channel. However, the

transceiver also transmits on the channel where Scan

is currently paused.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27

Pas de commentaire

Kenwood TK-3202 Manuel d'utilisateur Page 20