Kenwood VR-5080 Manuel d'utilisateur télécharger pdf (Page 39)

Chapter One : Connecting Your Devices

Connections

Connecting the Antennas

AM Loop Antenna

ANTENNA

GND

FM 75Ω

Your new receiver comes with an AM loop antenna for AM

radio reception. To connect the AM antenna:

1. Insert the antenna loop into the base and position the

loop.

2. Open the receiver’s antenna terminal levers.

3. Insert the antenna’s wires into the terminal as shown

above.

4. Close the antenna terminal levers to lock the wires in

place.

5. Adjust the antenna loop as necessary to improve recep-

tion.

To prevent hum interference, keep the AM antenna wires

away from speaker wires, AC power cords, the TV chassis,

and the receiver.

What if I Have Cable Radio?

If you have cable radio, contact your cable provider for as-

sistance with connecting to the VR-5700/VR-5090/VR-5080.

FM Indoor Antenna

Your new receiver also comes with an FM indoor antenna

for FM radio reception. To connect the FM antenna:

1. Attach the antenna sheath to the pole in the center of

the receiver’s FM antenna jack, as shown above. When

you attach the sheath for the first time, you may need to

exert quite a bit of pressure.

2. Adjust the antenna as necessary to improve reception.

3. Tack the looped end of the antenna in the location that

provides the best reception.

FM Outdoor Antenna

ANTENNA

GND

FM 75Ω

Kenwood recommends a permanently installed outdoor FM

antenna for best FM reception. To connect an outdoor FM

antenna:

1. Connect the antenna wire to a standard, commercially

available antenna adapter as shown above.

2. Connect the adapter to the receiver’s FM antenna jack.

ANTENNA

GND

FM 75Ω

RF Remote Antenna

RF REMOTE

ANTENNA

The Remote Control unit for the VR-5700/VR-5090/

VR-5080 communicates with the receiver via RF

transmission. To properly receive the RF remote sig-

nal, connect the provided RF Remote Antenna as

described below.

1. Insert the jack of the provided RF Remote Antenna

into the receiver’s RF REMOTE ANTENNA jack.

2. Distribute the antenna wire horizontally and fix it.

Distribute the antenna away from the metallic panel.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

Kenwood VR-5080 Manuel d'utilisateur Page 39

Commentaires sur ces manuels

Produits connexes et manuels pour DVR de voiture Kenwood VR-5080