Kenwood VR-5080 Manuel d'utilisateur télécharger pdf (Page 41)

Remote Setup

Chapter Two : Setting Up the Remote Control Unit

Selecting the input:

Audio device: Press the

MUSIC

button repeatedly. The in-

put names where audio devices are identi-

fied by Remote Control unit will be shown

on the LCD screen.

1CD1 :

2MD/Tape1 :

3Tuner :

4CD-R :

5Phono :

If an audio device which is connected to an

input is not identified by Remote Control

unit, the device name is skipped and not dis-

played.

Video device: Press the

MOVIE

button repeatedly. The input

names where video devices are identified by

Remote Control unit will be shown on the

LCD screen.

1Video1 :

2Video2 :

3Video3 :

4Video4 :

5DVD/6ch :

6AV AUX :

Remote Control unit is a new type of Remote Control unit

which receives information from the receiver and display it

on the LCD screen.

This section describes the basic operations of Remote Con-

trol unit.

Turning power on:

To turn the receiver on: Press the SYS.POWER button.

To turn the connected device on: Press the AV POWER but-

ton.

(It is necessary to perform the procedure in “Identifying

Components for Remote Control Unit” on page 39 to en-

able remote control of AV devices.)

Adjusting the receiver’s volume:

Press the VOL. (+/-) button until the de-

sired volume is obtained.

Muting audio temporarily:

Press the MUTE button.

To resume the original volume, press the MUTE button again

or press one of the VOL. (+/-) buttons.

Using the numeric buttons:

When entering a figure directly for selecting a CD track num-

ber, etc., press the numeric buttons as shown below.

To enter 5 :

To enter 25 :

The button to be pressed varies depending on the

function.

VOL.

Screen menu control operation

2WAY LCD REMOTE CONTROL UNIT

REC

The contents of the func-

tion buttons vary according

to current situations, and

the function names (Next,

Back, Enter, etc.) are shown

on the screen.

For details, see the descrip-

tion of each control opera-

tion.

Press to select an item by

scrolling the screen menu

up or down.

The selected item is dis-

played in an inverted color.

Basic Operation of Remote Control Unit

If a video device which is connected to an in-

put is not identified by Remote Control unit,

the device name is skipped and not displayed.

(VR-5080 only)

Although Video4 is displayed in the initial

status, the receiver cannot be switched to se-

lect Video4. The Video4 display will not ap-

pear after the Remote Control unit has been

set up.

TV: Press the

button. The LCD screen shows TV if

this is registered in and identified by Remote Control

unit.

01.IR

02.Surround

03.Contrast

Home Enter

LCD

Function

button 1

LCD

Function

button 2

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

Kenwood VR-5080 Manuel d'utilisateur Page 41

Commentaires sur ces manuels

Produits connexes et manuels pour DVR de voiture Kenwood VR-5080